/ 768kHz/32Bit AK4490EQ DAC I2S/DSD input 基板パターンから必要電源を考える(2)

768kHz/32Bit AK4490EQ DAC I2S/DSD input 基板パターンから必要電源を考える(2)

Isolated XMOS DSD DXD 384kHz high-quality USB to I2S/DSD PCB with ultralow noise regulator
http://www.diyinhk.com/shop/audio-kits/69-isolated-xmos-dsd-dxd-384khz-high-quality-usb-to-i2sdsd-pcb-with-ultralow-noise-regulator.html
      
結論:3.3V供給が正解と思われる!
2) The isolated clean side is powered by external regulated 3.3V(>50mA)
from the 20pin header labelled 3.3vINx2 and GND,
it is usually connected to the same 3.3v digital power
the DAC is using( over-voltage or reverse-voltage can damage
the xmos chip immediately, double check before power on).
Xmos will not start until it can detect the 3.3V on the isolated side is present.
      
絶縁されたクリーン側は
20ピンヘッダーラベル3.3vINx2とGNDからの外部安定化された3.3V(50mA以上)が供給される。
通常はDACが接続されているのと同じ3.3Vデジタル電源に接続されています。
(warning:過電圧や逆電圧を加えれば直ちにxmos chip にダメージを与える。
ダブルチェックした後にPower_ONしてください。)
絶縁側が存在する上で、それが3.3Vを検出できるようになるまで、XMOSは起動しません。

— posted by くま at 06:01 pm   pingTrackBack [0]

この記事に対するコメントはありません

<< 2016.1 >>
SMTWTFS
     1 2
34 5 6 7 8 9
1011121314 1516
1718 1920212223
24252627282930
31       
 
























T: Y: ALL: Online:
ThemePanel
Created in 0.0344 sec.