/ 雑記帳

[ Tags :: 一次直流抵抗 ]

やっぱり...AK4497のHLOADでも1KΩ程度で受けた方が高音質に聞こえる(^_^;)

うーん122Ωはドライブ出来ているように思えるがしかし
一次二次逆さの方が良く聞こえるな(^_^;)
何か勘違いなのか?

http://www.diyaudio.com/forums/digital-line-level/151568-dac-ouput-using-transformer-14.html
ここにこんな書き込みを見つけた!
この書き込みを書いた人は Sabre Buffalo24 を使っていて
600/600 transformers (Utc, Tamura, various Jensen) 色々試したが
低音域が上手く再生出来なくて Jensen JT-11P1, 10k/10k, を使ったらOKだったと(^_^;)
      
バッファロー(+と - )の両側の入力インピーダンスは185オームのようなものです。
2 x 1kを挿入すると、1次電圧の1/5が得られます
高インピーダンスのフィストリップは、それぞれEdcor 10k / 10k、13ドルで、どの600/600よりも優れた結果でした。 。 。
私が選択したJensen 10k / 10kは約1. 5kプライマリDCRなので、Source / loadの比率は約9です。
私のソリューションは最高だが、「最高のシンプルなソリューション」とは言いたくない! とか(笑)
      
   
Among many transformers 600/600 I've tried with Buff24, I've noticed as a first conclusion is that the best listening was always
with transfos which had the upper DCR, this is why UTC A-20, with 72-75 Ohms gave a "good" result...
I've tested 600/600 transfos, with up to 2 x 1.2k , and stopped to think about : if you add more resistance , it's become a
voltage divider, and the level at the secondary output becomes very low
The input impedance of each side of the Buffalo (+ and -) are something like 185 Ohms, if you insert 2 x 1k, the result gives you
1/5 of the primary voltage
The fisrt try with a high impedance was Edcor 10k/10k, 13$ each, and a better result than any 600/600...I was on the good way ....
The Jensen 10k/10k I choose are about 1.5k primary DCR, so the ratio Source/load is about 9.
I don't want to say that my solution is the best, but the "best simple solution" !
      
やったぜついに見つけた!!
やっぱり電圧出力型だと一次DCRがK(キロ)Ω単位のトランスをチョイスしている。
http://www.sowter.co.uk/dacs.php
http://www.sowter.co.uk/specs/3575.php

— posted by くま at 10:44 pm  

この記事に対するコメントはありません

<< 2024.3 >>
SMTWTFS
     12
3456 7 89
10 11 1213141516
17 1819 20 21 2223
24 25 26 27 282930
31      
 
























T: Y: ALL: Online:
ThemePanel
Created in 0.0442 sec.